700 Hawk Engine Build

Here is the "core" engine we're starting with. It's about to get shredded...
- Views: 3449
- By: Administrator
20 minutes later...
- Views: 3661
- By: Administrator
About an hour later. Everything will get cleaned, cleaned, and cleaned again.
- Views: 3582
- By: Administrator
Here is the crankshaft after the Falicon Supercrank modification. They lighten it about a pound, knife edge the counterweights,
- Views: 3452
- By: Administrator
Partway through the crankshaft buildup. Here the crank is held in the vice while all the clearances are checked and bearing sele
- Views: 3739
- By: Administrator
After the bearings are selected it is time to final assemble. Here you can see a micrometer being used to check bolt stretch. Ca
- Views: 3596
- By: Administrator
Crankshaft ready to install!
- Views: 3718
- By: Administrator
This engine will be using our #9 cam grind. It is similar to the 153x1 but has a bit more lift and duration, particularly on th
- Views: 3325
- By: Administrator
Stage 2 cylinder heads will be used, with +2mm intake valves and porting by my machinist/cylinder head guru Terry Reed. This cy
- Views: 3850
- By: Administrator

First Previous
Photos 1 - 9 of 33
Next Last

Popular tags

Random image

FZ-07 014